Print Back
Whole House Gas Furnace
  • 92% AFUE
  • Multi-position installation: downflow / horizontal left or right
  • Self-diagnostic control board continuously monitors the system for consistent and reliable operation
  • Durable tubular stainless-steel heat exchanger
  • Secondary stainless-steel heat exchanger for increased efficiency
  • Quiet multi-speed blower motor
  • Quiet single-speed induced draft blower
  • Durable silicon nitride igniter
  • Single-stage gas valve
  • Heavy-gauge steel cabinet with durable baked-enamel finish
  • Fully insulated heat exchanger and blower section
  • Optional continuous air circulation to keep the air moving throughout the home
Unit of Measure

Specifications

High-Fire Input

 N/A 100000 Btu/h

High-Fire Output

 N/A 92000 Btu/h

Annualized Fuel Utilization Efficiency

 N/A 92 %

Temperature Rise Range

 N/A 35 - 65ºF

Vent Diameter

 N/A 2 to 3 in

No. of Burners

 N/A 5

Min. Circuit Ampacity

 N/A 13.7 A

Max. Overcurrent Device

 N/A 15 A

Shipping Weight

 N/A 140 lb

Circulator Blower

Available AC

 N/A 2.5 to 4 A

Size (D x W)

 N/A 11 x 10

Horsepower

 N/A 3/4 hp

Speed

 N/A 4

RPM

 N/A 1075

Dimensions

Depth

 N/A 29 in

Width

 N/A 21 in

Height

 N/A 34 1/2 in

Features

N/A

Standard Features

  • Heavy-duty aluminized-steel tubular heat exchanger
  • Stainless-steel secondary heat exchanger
  • Single-stage gas valve
  • Durable Silicon Nitride igniter
  • Quiet single-speed induced draft blower
  • Self-diagnostic control board with constant memory fault code history output to a LED
  • All models comply with California 40 ng/J Low NOx emissions standard
  • AHRI Certified; ETL Listed

Cabinet Features

  • Designed for multi-position installation — DM92SS: upflow, horizontal left or right DC92SS: downflow, horizontal left or right
  • Certified for direct vent (2-pipe) or non-direct vent (1-pipe)
  • Easy-to-install top venting with optional side venting — DM92SS/upflow models only
  • Convenient left or right connection for gas and electrical service
  • Cabinet air leakage (QLeak) < 2%
  • Heavy-gauge steel cabinet with durable finish
  • Fully insulated heat exchanger and blower section
  • Airtight solid bottom or side return with easy-cut tabs for effortless removal in bottom air-inlet applications

Notes

N/A

  • All furnaces are manufactured for use on 115 VAC, 60 Hz, single-phase electrical supply.
  • Gas Service Connection 1/2" FPT
  • Important: Size fuses and wires properly and make electrical connections in accordance with the National Electrical Code and/or all existing local codes.
  • For bottom return: Failure to unfold flanges may reduce airflow by up to 18%. This could result in performance and noise issues.
  • For servicing or cleaning, a 24" front clearance is required. Unit connections (electrical, flue and drain) may necessitate greater clearances than the minimum clearances listed above. In all cases, accessibility clearance must take precedence over clearances from the enclosure where accessibility clearances are greater.